Home › Engine / Hybrid System › 1BZ-FPE (ENGINE MECHANICAL) › CYLINDER HEAD › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073200 1BZ-FPE ENGINE MECHANICAL _0356245 CYLINDER HEAD A

1BZ-FPE ENGINE MECHANICAL  CYLINDER HEAD  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Thoroughly clean all parts to be assembled.

·

Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.

·

Replace all gaskets and oil seals with new ones.



PROCEDURE

Hide 1.INSTALL SPARK PLUG TUBES

HINT:

When using a new cylinder head, spark plug tubes must be installed.


a.
A423709

Apply adhesive to the end of the spark plug tube.

Adhesive:

Part No. 08833-00070, THREE BOND 1324 or equivalent



b.
A423710

Using a press and wooden block, press in a spark plug tube.

HINT:
·

Press the spark plug tube until it hits the bottom.

·

After the installation, check that all the 4 spark plug tubes are in the same height.




Hide 2.INSTALL VALVES

a.
A423711

Install new oil seals on the valve guide bushings.

HINT:

Pushing down at the places shown in the illustration.



b.

Rotate the oil seal to check that it is firmly installed.


c.

Install the valve, spring seat, valve spring and spring retainer.


d.
A423712

Using SST, compress the valve spring and place the 2 keepers around the valve stem.


e.
A423713

Using a plastic-faced hammer, lightly tap the valve stem tip to assure a proper fit.


Hide 3.INSTALL VALVE BRIDGES AND PAD

a.
A423714

Install the valve bridge and pad.


b.

Check that the valve bridge rotates smoothly.