Home › Engine / Hybrid System › 1BZ-FPE (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073200 1BZ-FPE ENGINE MECHANICAL _0356246 CYLINDER BLOCK A

1BZ-FPE ENGINE MECHANICAL  CYLINDER BLOCK  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are 2 methods (A and B) to replace the oil seal which are as follows:


PROCEDURE

Hide 1.REPLACE CRANKSHAFT REAR OIL SEAL

a.

If rear oil seal retainer is removed from cylinder block:

i.
A423793

Using a screwdriver and hammer, tap out the oil seal.


ii.
A423794

Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010  


iii.

Apply MP grease to the oil seal lip.



b.

If rear oil seal retainer is installed to cylinder block:

i.
A423795

Using a knife, cut off the oil seal lip.


ii.

Using a screwdriver, pry out the oil seal.

NOTICE:

Be careful not to damage the crankshaft. Tape the screwdriver tip.



iii.

Apply MP grease to a new oil seal lip.


iv.
A423796

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010