Home › Engine / Hybrid System › 1BZ-FPE (FUEL) › LPG CARBURETOR › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073202 1BZ-FPE FUEL _0356253 LPG CARBURETOR G

1BZ-FPE FUEL  LPG CARBURETOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT THROTTLE SHAFT

a.
A422061

Check that the throttle shaft rotates smoothly when operating the throttle lever.


b.

With the throttle valve closed completely, check that the throttle shaft is properly positioned without looseness, while moving the shaft in the directions indicated by the arrows in the illustration.


Hide 23260T 2.INSPECT INJECTOR

a.
A422062

Measure the resistance between terminals.

Resistance:

3.5 - 4.5 Ω at 20 °C (68 °F)



Hide 89452A 3.INSPECT THROTTLE POSITION SENSOR

a.
A422063

Using an ohmmeter, measure the resistance between terminals 1 and 4.

Resistance:

2.5 - 11.5 kΩ



Hide 26280 4.INSPECT AIR FUEL RATIO CONTROL MOTOR

NOTICE:

"Cold" and "Hot" in these sentences express the temperature of the coils themselves. "Cold " is from -10 °C (14 °F) to 50 °C (122 °F) and "Hot" is from 50 °C (122 °F) to 100 °C (212 °F).


a.
A422064

Measure the resistance between terminals.

Resistance:

2 - 3 or 1:

15 - 25 Ω at Cold


Resistance:
2 - 3 or 1:

15 - 25 Ω at Cold

20 - 30 Ω at Hot

5 - 6 or 4:

15 - 25 Ω at Cold

20 - 30 Ω at Hot



b.

Inspect the air fuel ratio control motor operation.

i.

Connect the positive lead of the battery to terminals B1 and B2. Connect the negative lead of the battery to terminals in the order of S1 → S2 → S3 → S4 → S1 several times, and confirm that the valve moves to the "Close" side.


ii.

Connect the positive lead of the battery to terminals B1 and B2. Connect the negative lead of the battery to terminals in the order of S4 → S3 → S2 → S1 → S4 several times, and confirm that the valve moves to the "Open" side.