Home › Engine / Hybrid System › 1BZ-FPE (LUBRICATION) › OIL AND OIL FILTER › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073204 1BZ-FPE LUBRICATION _0356273 OIL AND OIL FILTER G

1BZ-FPE LUBRICATION  OIL AND OIL FILTER  INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL QUALITY

a.
A423820

Check the oil for deterioration, entry of water, discoloring or thinning.

If the quality is visibly poor, replace the oil.

Oil grade: API grade SL or better

Recommended viscosity: Refer to illustration


Hide 2.CHECK ENGINE OIL LEVEL

a.

The oil level should be between the "L" and "F" marks on the dipstick.

If low, check for leakage and add oil up to "F" mark.


Hide 83530 3.REMOVE OIL PRESSURE SWITCH

a.
A423821

Remove the oil pressure switch.


Hide 4.INSTALL OIL PRESSURE GAUGE

A423822

Hide 5.WARM UP ENGINE

a.

Allow the engine to warm up to normal operation temperature.


Hide 6.CHECK OIL PRESSURE

Oil pressure:

At idle: 29 kPa (0.3 kgf/cm2, 4.3 psi) or more

At 4,000 rpm: 245 - 588 kPa (2.5 - 6.0 kgf/cm2, 36 - 85 psi)


Hide 7.REMOVE OIL PRESSURE GAUGE

Hide 83530 8.REINSTALL OIL PRESSURE SWITCH

a.
A423823

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent



b.

Install the oil pressure switch.


Hide 9.START ENGINE, AND CHECK FOR OIL LEAKS