Home › Engine / Hybrid System › 1BZ-FPE (LUBRICATION) › OIL PUMP › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073204 1BZ-FPE LUBRICATION _0356274 OIL PUMP G

1BZ-FPE LUBRICATION  OIL PUMP  INSPECTION  


PROCEDURE

Hide 15131 1.INSPECT RELIEF VALVE

a.
A423838

Coat the valve with engine oil and check that it falls smoothly into the valve hole by its own weight.

If it doesn't replace the relief valve. If necessary, replace the oil pump assembly.


Hide 15121B 2.INSPECT DRIVE AND DRIVEN ROTORS

a.
A423839

Inspect rotor tip clearance

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.

Standard tip clearance:

0.110 - 0.240 mm (0.0043 - 0.0094 in.)


Maximum tip clearance:

0.30 mm (0.0118 in.)


If the tip clearance is greater than maximum, replace the rotors as a set.


b.
A423840

Inspect rotor body clearance

Using a feeler gauge, measure the clearance between the driven rotor and body.

Standard tip clearance:

0.144 - 0.229 mm (0.0035 - 0.0090 in.)


Maximum tip clearance:

0.40 mm (0.0157 in.)


If the body clearance is greater than maximum, replace the rotors as a set. If necessary, replace the oil pump assembly.


c.
A423841

Inspect rotor side clearance

Using a feeler gauge and precision straight edge, measure the clearance between the rotors and precision straight edge.

Standard tip clearance:

0.035 - 0.090 mm (0.0014 - 0.0035 in.)


Maximum tip clearance:

0.40 mm (0.0157 in.)


If the side clearance is greater than maximum, replace the rotors as a set. If necessary, replace the oil pump assembly.


Hide 13434 3.INSPECT DRIVE SPLINE

a.
A423842

Using a dial indicator, measure the backlash while turning the drive rotor clockwise and counterclockwise in several places.

Standard backlash:

0.541 - 0.790 mm (0.0213 - 0.0311 in.)


Maximum backlash:

1.00 mm (0.0394 in.)


If the backlash is greater than maximum, replace the rotor and spline.