13434
1.REMOVE DRIVE SPLINE
Remove the 2 set keys.
Set the drive spline with the hole facing downward by turning the crankshaft.
Using a chisel and hammer, tap the drive spline out of the hole until SST can be hooked to spline's end.
Install a standard bolt (Part No. 90101-16027: 16 mm normal diameter, 1.5 mm pitch) to the crankshaft.
Using SST, remove the drive spline.
Remove the standard bolt.
13434
2.INSTALL NEW DRIVE SPLINE
Using SST and a hammer, tap in the drive spline.
Install the 2 set keys.