Home › Engine / Hybrid System › 1BZ-FPE (STARTING) › STARTER › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073205 1BZ-FPE STARTING _0356278 STARTER A

1BZ-FPE STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE DUST PROTECTOR

Hide 2.REMOVE LEAD WIRE

a.
A423871

Remove the screw and lead wire from the terminal 50.


Hide 3.REMOVE FIELD FRAME WITH ARMATURE FROM MAGNETIC SWITCH ASSEMBLY

a.

Remove the nut, and disconnect the lead wire from the terminal C and remove the plate washer.

Torque:

24 N*m (244 kgf*cm, 18 ft*lbf)



b.
A423872

Remove the 2 through bolts.

Torque:

9.3 N*m (95 kgf*cm, 82 in.*lbf)



c.
A423873

Pull out the field frame together with the armature.

HINT:

Align the protrusion of the field frame with the indentation of the magnetic switch.



d.

Remove the felt washer.


e.

Remove dust protector.


Hide 4.REMOVE STARTER HOUSING, CLUTCH ASSEMBLY AND GEAR

a.
A423874

Remove the 3 screws and starter housing.

Torque:

9.3 N*m (95 kgf*cm, 82 in.*lbf)



b.
A423875

Remove these parts from the magnetic switch:

(1) Clutch assembly

(2) Return spring

(3) Idler gear

(4) Bearing

(5) Plate washer



Hide 5.REMOVE STEEL BALL

a.
A423876

Using a magnetic finger, remove the steel ball from the clutch shaft hole.


Hide 6.REMOVE BRUSH HOLDER

a.
A423877

Remove the 2 screws and end cover from the field frame.


b.
A423878

Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.


c.

Disconnect the 4 brushes, and remove the brush holder.


Hide 7.REMOVE ARMATURE FROM FIELD FRAME