Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for RHD vehicles.
88605
1.REMOVE NO. 1 COOLER WIRING HARNESS SUB-ASSEMBLY
Detach the clamp.
Remove the 2 bolts, 2 screws and cooling unit case plate RH.
Remove the bolt and bracket.
Detach the clamp.
Remove the 2 bolts, 2 screws and cooling unit case plate center.
Remove the 2 bolts, 2 screws and cooling unit case plate LH.
Remove the 6 screws.
Detach each clamps, disconnect each connectors and remove the No. 1 cooler wiring harness sub-assembly.
87103B
2.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY
Remove the 12 screws and 4 blower motor with fan sub-assemblies.
87138C
3.REMOVE BLOWER RESISTOR
Remove the 8 screws and 4 blower resistors.
88716Z
4.REMOVE NO. 1 LIQUID TUBE
Remove the 2 screws and dust cover.
Remove the packing.
Loosen the union nut and remove the No. 1 liquid tube.
88515
5.REMOVE COOLER EXPANSION VALVE
Remove the packing.
Remove the clamp.
Loosen the 2 union nuts and remove the cooler expansion valve.
88717V
6.REMOVE NO. 1 SUCTION TUBE
Loosen the union nut and remove the No. 1 suction tube.
7.REMOVE LOWER COOLING UNIT CASE
Remove the packing.
Remove the 35 screws and lower cooling unit case.
88501
8.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove the 5 bolts and No. 1 cooler evaporator sub-assembly.
88625
9.REMOVE NO. 1 COOLER THERMISTOR
Detach the clamp and remove the No. 1 cooler thermistor from the No. 1 cooler evaporator sub-assembly.
Remove the clamp.