88688K
1.REMOVE COOLER COMPRESSOR BRACKET
Detach the connector clamp.
Remove the bolt and cooler compressor bracket.
88410
2.REMOVE MAGNET CLUTCH ASSEMBLY
Clamp the compressor and magnet clutch in a vise.
| *1 | Magnet Clutch Hub |
Using SST, secure the magnet clutch hub.
Remove the nut, magnet clutch hub and magnet clutch washer(s).
There is no set number of magnet clutch washers since they are used for adjusting.
Using a snap ring expander, remove the snap ring and the magnet clutch rotor.
| *1 | Magnet Clutch Rotor |
Do not damage the seal cover of the bearing when removing the snap ring.
Remove the bolt and separate the ground wire.
| *1 | Magnet Clutch Stator |
Remove the 3 bolts and magnet clutch stator.