Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for RHD vehicles.
55905J
1.REMOVE CONTROL KNOB SUB-ASSEMBLY
Remove the control knob sub-assemblies.
55519
2.REMOVE HEATER CONTROL NAME PLATE
Using a heat light, heat the air conditioner control assembly surface.
| Item | Temperature |
|---|---|
| Air Conditioner Control Assembly | 20 to 30°C (68 to 86°F) |
Do not heat the air conditioner control assembly excessively.
Remove the heater control name plates.
84732H
3.REMOVE HEATER BLOWER SWITCH (w/ Front Heater System)
Remove the 7 screws.
Detach the 4 claws and remove the base plate.
Remove the screw.
Disconnect the heater blower switch bulb socket by turning it in the direction of the black arrow shown in the illustration.
Detach the claw, pull in the direction of the white arrow shown in the illustration and remove the heater blower switch.
55906A
4.REMOVE DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY
| *A | for RHD |
| *B | for LHD |
Open the claw of the clamp on the defroster damper control cable sub-assembly right and left and pull out the defroster damper control cable sub-assembly from the clamp.
Pull out the end of the defroster damper control cable sub-assembly inner cable from the control lever and remove the defroster damper control cable sub-assembly.
55909A
5.REMOVE AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY
| *A | for RHD |
| *B | for LHD |
Open the claw of the clamp on the air mix damper control cable sub-assembly right and left and pull out the air mix damper control cable sub-assembly from the clamp.
Pull out the end of the air mix damper control cable sub-assembly inner cable from the control lever and remove the air mix damper control cable sub-assembly.
84732L
6.REMOVE REAR HEATER BLOWER SWITCH (w/ Rear Heater System)
Detach the 4 claws and disconnect the rear heater blower switch bulb socket.
Detach the claw, pull in the direction of the arrow shown in the illustration and remove the rear heater blower switch.
84660H
7.REMOVE COOLER CONTROL SWITCH ASSEMBLY (w/ Cooler System)
Detach the 2 claws and remove the cooler control switch assembly.
84732E
8.REMOVE COOLER BLOWER SWITCH (w/ Cooler System)
Disconnect the connector.
Detach the 8 claws and remove the cooler control switch assembly of the cover.
Detach the claw and remove the cooler blower switch as shown in the illustration.
81936B
9.REMOVE COOLER CONTROL BULB ASSEMBLY
Rotate and remove the 2 cooler control bulb assemblies.
84732K
10.REMOVE HEATER BLOWER SWITCH BULB (w/ Front Heater System)
Remove the heater blower switch bulb.
84732N
11.REMOVE REAR HEATER BLOWER SWITCH BULB (w/ Rear Heater System)
Remove the rear heater blower switch bulb.