1.REMOVE MAGNETIC CLUTCH ASSEMBLY
Clamp the compressor in a vise.
Using vise pliers, secure the magnetic clutch hub.
Use a shop rag or piece of cloth so as not to damage the magnetic clutch hub.
Remove the nut, magnetic clutch hub and magnetic clutch washers.
There is no set number of magnetic clutch washers since they are used for adjusting.
Using a snap ring expander, remove the snap ring and the magnetic clutch rotor.
Do not damage the seal cover of the bearing when removing the snap ring.
Disconnect the connector clamp.
Remove the screw and separate the earth wire.
Remove the 3 bolts and magnetic clutch stator.