Home › Vehicle Interior › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH(for 2TR-FE)
RM2850E _58 Vehicle Interior _073207 AIR CONDITIONING _0356291 COMPRESSOR AND MAGNETIC CLUTCH(for 2TR-FE) A

AIR CONDITIONING  COMPRESSOR AND MAGNETIC CLUTCH(for 2TR-FE)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL MAGNETIC CLUTCH ASSEMBLY

a.
E156344

Install the magnetic clutch stator with the 3 bolts.

Torque:

7.9 N*m (80 kgf*cm, 69 in.*lbf)



b.

Connect the connector clamp.


c.
E156346

Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing outward.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



d.

Install the magnetic clutch washers and magnet clutch hub.

NOTICE:

Do not change the combination of the magnetic clutch washers used before disassembly.



e.

Using vise pliers, secure the magnetic clutch hub and install the nut.

Torque:

23 N*m (235 kgf*cm, 17 ft.*lbf)


NOTICE:
·

Use a shop rag or piece of cloth so as not to damage the clutch hub.

·

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.




Hide 2.INSPECT MAGNETIC CLUTCH CLEARANCE

a.
E156348E03
1.51,2.615 1.51,2.917 true 0.5,0.865 0.906,0.865 true 2.646,1 3.354,1.271 0.708,0.271 10 false Battery 0.823,2.969 2.552,3.302 1.729,0.333 10 false Magnetic Clutch Hub 0.167,0.792 0.625,0.99 0.458,0.198 10 false MG+

Clamp the compressor in a vise.


b.

Set the dial indicator to the magnetic clutch hub.


c.

Connect the positive battery lead to terminal 1 (MG+) of the magnetic clutch connector and the negative lead to the earth wire. Turn the magnetic clutch on and off and measure the clearance.

Standard clearance:

0.6 to 1.0 mm (0.024 to 0.039 in.)


If the measured value is not within the standard clearance, remove the magnetic clutch hub and adjust the clearance using a magnetic clutch washer or combination thereof.

NOTICE:

Adjustment should be performed with 3 or less magnetic clutch washers.



d.

Remove the compressor from the vise.