88688K
1.REMOVE COOLER COMPRESSOR BRACKET
Disconnect the connector clamp.
Remove the bolt and bracket.
88410
2.REMOVE MAGNETIC CLUTCH ASSEMBLY
Clamp the compressor in a vise.
Using SST, secure the magnetic clutch hub.
Remove the bolt, magnetic clutch hub and magnetic clutch washers.
There is no set number of magnetic clutch washers since they are used for adjusting.
Using a snap ring expander, remove the snap ring and the magnetic clutch rotor.
Do not damage the seal cover of the bearing when removing the snap ring.
Remove the screw and ground wire.
Remove the 3 bolts and magnetic clutch stator.