Home › Vehicle Interior › AIR CONDITIONING › COMPRESSOR (for N04C-UH)
RM2850E _58 Vehicle Interior _073207 AIR CONDITIONING _0356304 COMPRESSOR(for N04C-UH) A

AIR CONDITIONING  COMPRESSOR(for N04C-UH)  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNETIC CLUTCH ASSEMBLY

a.
I103030

Install magnetic clutch starter with the 3 bolts.

Torque:

7.9 N*m (81 kgf*cm, 70 in.*lbf)



b.

Install the ground wire with the screw.


c.
I103028

Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing outward.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



d.

Install the magnetic clutch washers and magnet clutch hub.

NOTICE:

Do not change the combination of the magnetic clutch washers used before disassembly.



e.
I105369E03
0.688,1 0.927,0.948 false 0.344,0.948 0.948,1.177 0.604,0.229 10 false SST

Using SST, secure the magnetic clutch hub and install the bolt.

SST
09985-00030  

Torque:

23 N*m (230 kgf*cm, 17 ft.*lbf)


NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 88410 2.INSPECT MAGNETIC CLUTCH CLEARANCE

a.
I103031E06
1.49,2.792 1.667,3.021 true 0.5,0.844 0.865,0.844 true 0.323,0.25 0.688,0.479 0.365,0.229 10 false *a 0.854,0.76 1.219,0.99 0.365,0.229 10 false 1 2.906,1 3.271,1.229 0.365,0.229 10 false *2 1.615,3.031 1.979,3.26 0.365,0.229 10 false *1 0.146,0.76 0.604,0.958 0.458,0.198 10 false MG+

Clamp the compressor in a vise.


b.

Set the dial indicator to the magnetic clutch hub.


c.

Connect the positive battery lead to terminal 1 (MG+) of the magnetic clutch connector and the negative lead to the ground wire. Turn the magnetic clutch on and off and measure the clearance.

Standard clearance:

0.6 to 1.0 mm (0.024 to 0.039 in.)


Text in Illustration
*1 Magnet Clutch Hub
*2 Battery

If the measured value is not within the standard clearance, remove the magnetic clutch hub and adjust the clearance using a magnetic clutch washer or combination of washers.

NOTICE:

Adjustment should be performed with 3 or less magnetic clutch washers.



d.

Remove the compressor from the vise.


Hide 88688K 3.INSTALL COOLER COMPRESSOR BRACKET

a.
I103027

Install the bracket with the bolt.


b.

Connect the connector clamp.