1.REMOVE PRESSURE PLATE
Using SST and socket wrench, remove the shaft nut.
SST 07112-67010
Using SST and socket wrench, remove the pressure plate.
SST 07112-71010
Remove the shims from the shaft.
2.REMOVE ROTOR
Using SST, remove the snap ring.
SST 07114-84020
Using a plastic hammer, tap the rotor off the shaft.
Be careful not to damage the pulley when tapping on the rotor.
3.REMOVE STATOR
Using SST, remove the snap ring.
SST 07114-84020
Disconnect the stator lead wire from the compressor housing.
Remove 3 bolts and the stator.