Home › Vehicle Interior › AIR CONDITIONING › COMPRESSOR (for 14B) › 2017.01–2019.08
RM2850E _58 Vehicle Interior _073207 AIR CONDITIONING _0356307 COMPRESSOR(for 14B) A

AIR CONDITIONING  COMPRESSOR(for 14B)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL STATOR

a.
E394773

Install the stator with 3 bolts.

Torque:

8 N*m (80 kgf*cm, 69 in.*lbf)



b.
E394774

Using SST, install the new snap ring.

SST 07112-84020


c.

Connect the stator lead wire to the compressor housing.


Hide 2.INSTALL ROTOR

a.
E394775

Install the rotor on the compressor shaft.


b.

Using SST, install the new snap ring.

SST 07114-84020


Hide 3.INSTALL PRESSURE PLATE

a.
E394776

Adjust the clearance between the pressure plate and rotor by putting shims on the compressor shaft.

Standard clearance:

0.4 - 0.7 mm (0.016 - 0.028 in.)


If the clearance is not within tolerance, add or reduce the number of shims to obtain the standard clearance.


b.
E394777

Using SST and torque wrench, install the shaft nut.

SST 07110-67010

Torque:

16 N*m (165 kgf*cm, 12 ft.*lbf)



Hide 4. CHECK CLEARANCE OF MAGNETIC CLUTCH

a.
E394778

Set the dial indicator to the pressure place of the magnetic clutch.


b.

Connect the magnetic clutch lead wire to the positive (+) terminal of the battery.


c.

Check the clearance between the pressure plates and rotor, when connect the negative (-) terminal of the battery.

Standard clearance:

0.4 - 0.7 mm (0.016 - 0.028 in.)


If the clearance is not within standard clearance, adjust the clearance using shims to obtain the standard clearance.