Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for RHD vehicles.
87441B
1.INSTALL HEATER AIR FILTER
for Paper Type:
Install the heater air filter.
Install the air filter with its UP marks oriented in the correct direction.
for Resin Type:
Attach the 2 claws to install the heater air filter.
87114C
2.INSTALL HEATER COVER
Attach the 2 guides.
Attach the claw to install the heater cover.
87138
3.INSTALL HEATER BLOWER RESISTOR
Install the heater blower resistor with the 2 screws.
87103G
4.INSTALL FRONT HEATER BLOWER CASE SUB-ASSEMBLY
Install the front heater blower case sub-assembly with the 3 bolts.
Install the clamp bracket with the screw.
87107
5.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
Install new 2 O-rings to the heater water inlet pipe A and heater water outlet pipe A.
Keep the O-rings and O-ring fitting surfaces clean from dirt or any foreign objects.
Install the 2 clamp clips with the 2 screws.
Install the heater radiator unit sub-assembly.
Install the 2 clamps with the 2 screws.
87211A
6.INSTALL NO. 2 AIR DUCT
Attach the 4 claws to install the No. 2 air duct.
87211
7.INSTALL NO. 1 AIR DUCT
Attach the 3 claws to install the No. 1 air duct.
Install the clip.