Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81156A
1.INSTALL HEADLIGHT BRACKET LH
Install the headlight bracket LH with the screw.
Align the 2 No. 1 gear unit assemblies LH 2 cutouts and the 2 aiming screws, and then set into place.
| *a | Aiming Screw |
| *b | Cutout |
Install the 4 screws.
81176C
2.INSTALL NO. 1 HEADLIGHT COVER LH
Attach the hook to set the No. 1 headlight cover LH.
Install the 2 screws.
81165
3.INSTALL HEADLIGHT CORD LH
Attach the 3 wire harness clamps to set the headlight cord LH.
Attach the claw to connect the connector.
Connect the No. 1 headlight bulb connector.
Return the cover to its original position.
Install the front turn signal light bulb to the bulb socket.
Align the matchmark of the front turn signal light bulb socket to the unlock mark, and then rotate it clockwise until the lock mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
Install the No. 1 headlight bracket LH with the 2 screws.
Install the clearance light bulb to the bulb socket.
Align the matchmark of the clearance light bulb socket to the unlock mark, and then rotate it clockwise until the lock mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
81110B
4.INSTALL NO. 1 HEADLIGHT BULB
Set the No. 1 headlight bulb into place.
Do not touch the glass part of the No. 1 headlight bulb.
Return the set spring to its original position.
Connect the connector.
Return the cover to its original position.
81510D
5.INSTALL FRONT TURN SIGNAL LIGHT BULB
Install the front turn signal light bulb to the bulb socket.
Align the matchmark of the bulb socket to the unlock mark, and then rotate it clockwise until the lock mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
81118E
6.INSTALL NO. 1 HEADLIGHT BRACKET LH (for Driver Side)
Install the No. 1 headlight bracket LH with the 2 screws.
81610F
7.INSTALL CLEARANCE LIGHT BULB
Install the clearance light bulb to the bulb socket.
Align the matchmark of the bulb socket to the unlock mark, and then rotate it clockwise until the lock mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |