Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR BUMPER ASSEMBLY
64746
2.REMOVE REAR COMBINATION LIGHT SERVICE COVER LH
Using a screwdriver, insert the screwdriver into the cutout and detach the 7 claws.
Tape the screwdriver tip before use.
Slide the rear combination light service cover LH to detach the 2 guides to remove it.
|
Protective Tape | - | - |
81560
3.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
Disconnect the connector.
Remove the 3 nuts
Apply protective tape around the rear combination light assembly LH.
|
Protective Tape |
Remove the 3 screws.
Pull the rear combination light assembly LH toward the rear of the vehicle to detach the 2 pins and clip to remove it.
If the rear combination light body gasket has been damaged, replace it with a new one.