Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
52563D
1.REMOVE UPPER REAR BUMPER RETAINER LH
Detach the 2 guides to remove the upper rear bumper retainer LH.
81550H
2.REMOVE TAIL AND STOP LIGHT BULB
Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock mark to disconnect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
Remove the tail and stop light bulb from the bulbsocket.
81550L
3.REMOVE REAR TURN SIGNAL LIGHT BULB
Detach the wire harness clamp.
Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock mark to disconnect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
Remove the rear turn signal light bulb from the bulb socket.
81550N
4.REMOVE BACK UP LIGHT BULB
Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock mark to disconnect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
Remove the back up light bulb from the bulb socket.
81562B
5.REMOVE REAR COMBINATION LIGHT BODY PACKING LH
Remove the rear combination light body packing LH.
The rear combination light body packing LH must not be reused.
81565D
6.REMOVE REAR COMBINATION LIGHT CORD LH
Turn the tail and stop light bulb socket counterclockwise until the matchmark is aligned with the unlock mark to disconnect the tail and stop light bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
Remove the tail and stop light bulb from the bulb socket.
Detach the wire harness clamp.
Turn the rear turn signal light bulb socket counterclockwise until the matchmark is aligned with the unlock mark to disconnect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
Remove the rear turn signal light bulb from the bulb socket.
Turn the back up light bulb socket counterclockwise until the matchmark is aligned with the unlock mark to disconnect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
Remove the back up light bulb from the bulb socket.
Disconnect the connector.
| *a | Wire Harness Clamp |
| *b | Connector Clamp |
Detach the 2 wire harness clamps and connector clamp to remove the rear combination light cord LH.