Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81565D
1.INSTALL REAR COMBINATION LIGHT CORD LH
Attach the 2 wire harness clamps and connector clamp to set the rear combination light cord LH.
| *a | Wire Harness Clamp |
| *b | Connector Clamp |
Connect the connector.
Install the back up light bulb to the bulb socket.
Align the matchmark of the back up light bulb socket to the unlock position mark, and then rotate it clockwise until the lock position mark to connect the back up light bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
Install the rear turn signal light bulb to the bulb socket.
Align the matchmark of the rear turn signal light bulb socket to the unlock position mark, and then rotate it clockwise until the lock position mark to connect the rear turn signal light bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
Install the tail and stop light bulb to the bulb socket.
Align the matchmark of the tail and stop light bulb socket to the unlock position mark, and then rotate it clockwise until the lock position mark to connect the tail and stop light bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
81562B
2.INSTALL REAR COMBINATION LIGHT BODY PACKING LH
Clean the installation area.
Remove the peeling paper from a new rear combination light body packing LH.
Align the 5 guides to set the rear combination light body packing LH.
| *a | Guide |
Push the rear combination light body packing LH.
81550N
3.INSTALL BACK UP LIGHT BULB
Install the back up light bulb to the bulb socket.
Align the matchmark of the bulb socket to the unlock position mark, and then rotate it clockwise until the lock position mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
81550L
4.INSTALL REAR TURN SIGNAL LIGHT BULB
Install the rear turn signal light bulb to the bulb socket.
Align the matchmark of the bulb socket to the unlock position mark, and then rotate it clockwise until the lock position mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
81550H
5.INSTALL TAIL AND STOP LIGHT BULB
Install the tail and stop light bulb to the bulb socket.
Align the matchmark of the bulb socket to the unlock position mark, and then rotate it clockwise until the lock position mark to connect the bulb socket.
| *a | Matchmark |
| *b | Unlock Mark |
| *c | Lock Mark |
52563D
6.INSTALL UPPER REAR BUMPER RETAINER LH
Attach the 2 guides to install the upper rear bumper retainer LH.