Home › Vehicle Interior › LIGHTING › STOP LIGHT SWITCH
RM2850E _58 Vehicle Interior _073208 LIGHTING _0356325 STOP LIGHT SWITCH A

LIGHTING  STOP LIGHT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

NOTICE:
·

When installing the stop light switch assembly, do not depress the brake pedal.

·

Operate it while supporting it with one hand so that the brake pedal does not move.



a.
E363271

Turn the stop light switch assembly clockwise to temporarily install it.


b.
E363272E01
1.708,1.688 1.906,1.865 0.198,0.177 10 true *a

Adjust the amount of protrusion of the shaft of the stop light switch assembly until it meets the standard.

Text in Illustration
*a Protrusion Amount Measurement Area

Standard:

0.5 to 2.4 mm (0.0197 to 0.0945 in.)



c.

Tighten the lock nut.


d.

Connect the connector.