Home › Vehicle Interior › LIGHTING › TURN SIGNAL FLASHER ASSEMBLY
RM2850E _58 Vehicle Interior _073208 LIGHTING _0356326 TURN SIGNAL FLASHER ASSEMBLY A

LIGHTING  TURN SIGNAL FLASHER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE INSTRUMENT PANEL ASSEMBLY

Hide 81980 4.REMOVE TURN SIGNAL FLASHER ASSEMBLY

a.
E363277

Disconnect the connector.


b.

Detach the clamp to remove the turn signal flasher assembly.