Use the same procedure for RHD and LHD vehicles.
The procedure listed below are for RHD vehicles.
85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY
With the ignition switch turned on, check the position that the washer fluid hits the windshield.
Washer fluid hits the windshield in the areas shown in the illustration.
| *a | Tip of Windshield Glass | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 445 mm (17.520 in.) | B | 482 mm (18.976 in.) |
| C | 201 mm (87.913 in.) | D | 570 mm (22.441 in.) |
| E | 1020 mm (40.157 in.) | F | 100 mm (3.937 in.) |
If the result is not as specified, adjust the washer nozzle sub-assembly (Click hereVehicle Interior>WIPER / WASHER>WASHER NOZZLE (for Front Side)>ADJUSTMENT).