Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
87940
1.INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH
Check the operation of the mirror surface.
Apply battery voltage and check the operation of the mirror.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1 (MV)
Battery negative (-) → Terminal 3 (M+) |
Turns upward |
| Battery positive (+) → Terminal 3 (M+)
Battery negative (-) → Terminal 1 (MV) |
Turns downward |
| Battery positive (+) → Terminal 2 (MH)
Battery negative (-) → Terminal 3 (M+) |
Turns left |
| Battery positive (+) → Terminal 3 (M+)
Battery negative (-) → Terminal 2 (MH) |
Turns right |
If the result is not as specified, replace the outer rear view mirror assembly LH.
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |
Check the retractable mirror.
For each position: Disconnect the battery, set the mirror position by hand, connect the battery, and check the retractable mirror movement.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5(MF)
Battery negative (-) → Terminal 4(MR) |
Retracted position |
| Battery positive (+) → Terminal 4(MF)
Battery negative (-) → Terminal 5(MF) |
Driving position |
If the result is not as specified, replace the outer rear view mirror assembly LH.
| *a | Component without harness connected
(Outer Rear View Mirror Assembly LH) |