Home › Vehicle Interior › ENGINE HOOD / DOOR › AUTO CENTER DOOR (for Glide Type) › 2017.01–2019.08
RM2850E _58 Vehicle Interior _073213 ENGINE HOOD / DOOR _0356367 AUTO CENTER DOOR(for Glide Type) G

ENGINE HOOD / DOOR  AUTO CENTER DOOR(for Glide Type)  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below are for RHD vehicles.



PROCEDURE

Hide 85620 1.INSPECT AUTOMATIC DOOR REGULATOR MOTOR ASSEMBLY

a.
B238833E03
0.115,0.125 0.427,0.323 0.313,0.198 10 false *1 2.094,2.552 2.406,2.75 0.313,0.198 10 false *a 1.167,2.063 1.323,2.271 0.156,0.208 10 true *b

Check the resistance of the automatic changeover handle position detection switch.

Text in Illustration
*1 Component without harness connected
(Automatic door regulator motor assembly)
*a Automatic
*b Manual

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 - 5 Automatic 10 kΩ or higher
2 - 5 Manual Below 1 Ω


If the result is not as specified, replace the automatic door regulator motor assembly.