84931B
1.INSPECT DOOR CONTROL SWITCH
Check the resistance.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
Keep the door control switch ON.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 4(B) - 1(OPN) | Switch pressed in(OPEN) | Below 1 Ω |
| 1(OPN) - 2(CLS) | Switch released (OFF) | 10 kΩ or higher |
| 2(CLS) - 4(B) | Switch pressed in(CLOSE) | Below 1 Ω |
Check the switch illuminates.
Apply battery voltage to the door control switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4(B)
Battery negative (-) → 3(IND-) |
LED illuminates |
| *a | Component without harness connected
(Door Control Switch) |
If the result is not as specified, replace the door control switch.