Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
69207S
1.REMOVE REAR DOOR INSIDE HANDLE COVER
Remove the 3 bolts.
Detach the guide and remove the rear door inside handle cover.
69281
2.REMOVE GLIDE DOOR INSIDE HANDLE
Detach and remove the snap ring as shown in the diagram, and then remove the glide door inside handle.
Remove the plate.
67680A
3.REMOVE GRIDE DOOR TRIM ASSEMBLY
Detach the 11 clips and remove the glide door trim assembly.
67690
4.REMOVE LOWER GLIDE DOOR TRIM ASSEMBLY
Detach the 8 clips and remove the lower glide door trim assembly.
67841A
5.REMOVE GLIDE DOOR SERVICE HOLE COVER
Remove the glide door service hole cover.
Remove any butyl tape remaining on the door.
68630B
6.REMOVE GLIDE DOOR CHECK ASSEMBLY
Remove the glide door check pin and door check pin retainer.
Do not reuse the door check pin retainer.
Remove the 4 bolts and the glide door check assembly.
69290E
7.REMOVE GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY
Disconnect the connector.
Disconnect the 2 links.
Remove the 3 bolts and glide door inside handle base assembly.
69230A
8.REMOVE GLIDE DOOR OUTSIDE HANDLE ASSEMBLY
Disconnect the link from the glide door outside handle assembly.
Remove the 4 screws and the glide door outside handle assembly.
69701D
9.REMOVE UPPER DOOR LOCK CONTROL BELLCRANK SUB-ASSEMBLY
Disconnect the link.
Remove the guide and bolt.
Remove the door lock control knob, then remove the upper door lock control bellcrank sub-assembly.
69751C
10.REMOVE GLIDE DOOR DOOR LOCK CONTROL KNOB HOLDER
Detach the 2 claws and remove the glide door lock control knob holder.
69530E
11.REMOVE GLIDE DOOR LOCK CYLINDER ASSEMBLY
Disconnect the link.
Remove the retainer and glide door lock cylinder assembly.
69330B
12.REMOVE FRONT GLIDE DOOR LOCK ASSEMBLY
Disconnect the clamp and connector.
Disconnect the link.
Remove the 4 bolts and front glide door lock assembly.
85450A
13.REMOVE DOOR CONTROL MOTOR ASSEMBLY
Disconnect the connector.
Remove the bolt <A>, spacer and washer.
Remove the 3 bolts <B> and the door control motor assembly.
| *a | Bolt <A> |
| *b | Bolt <B> |
| *c | Spacer |
| *d | Washer |
|
Bolt |
|
Connector |
69630A
14.REMOVE GLIDE DOOR LOCK REMOTE CONTROL ASSEMBLY
Disconnect the link.
Remove the 3 bolts and glide door lock remote control assembly.
69340A
15.REMOVE REAR GLIDE DOOR LOCK ASSEMBLY
Disconnect the connector.
Remove the 3 bolts and the rear glide door lock assembly.
84231A
16.REMOVE COURTESY LIGHT SWITCH
Remove the nut and the courtesy light switch.