75552H
1.REMOVE ROOF DRIP SIDE MOULDING LH
Apply protective tape around the roof drip side moulding LH.
Using a heat light, heat the roof drip side moulding LH.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60 °C (104 to 140 °F) |
| Roof Drip Side Moulding LH | 20 to 30 °C (68 to 86 °F) |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Using moulding remover A, detach the clip and remove the roof drip side moulding LH.
| *a | Double Sided Tape |
|
Protective Tape |
When removing the roof drip side moulding LH, make sure not to damage the roof drip side moulding clip.
If the roof drip side finish moulding clip is damaged, replace it with a new one.
75551H
2.REMOVE ROOF DRIP SIDE MOULDING RH
Use the same procedure described for the LH side.