Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
75896M
1.REMOVE NO. 2 MOULDING TAPE
When removing the No. 2 moulding tape, heat the vehicle body and No. 2 moulding tape using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60 °C (104 to 140 °F) |
| No. 2 Moulding Tape | 20 to 30 °C (68 to 86 °F) |
Do not heat the vehicle body or No.2 moulding tape excessively.
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Pull back an edge of the No. 2 moulding tape and pull it parallel to the vehicle body to remove it.
75895L
2.REMOVE NO. 1 MOULDING TAPE
When removing the No. 1 moulding tape, heat the vehicle body and No. 1 moulding tape using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60 °C (104 to 140 °F) |
| No. 1 Moulding Tape | 20 to 30 °C (68 to 86 °F) |
Do not heat the vehicle body or No. 1 moulding tape excessively.
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Pull back an edge of the No. 1 moulding tape and pull it parallel to the vehicle body to remove it.
75984A
3.REMOVE SLIDE DOOR STRIPE
When removing the slide door stripe, heat the vehicle body and slide door stripe using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60 °C (104 to 140 °F) |
| Slide Door Stripe | 20 to 30 °C (68 to 86 °F) |
Do not heat the vehicle body or slide door stripe excessively.
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Remove the tab tape.
Pull back on an edge of the slide door stripe and pull it parallel to the vehicle body to remove it.
| *a | Tab Tape | - | - |