Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID (w/o Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356443 BRAKE FLUID(w/o Brake pedal Load Sensing Switch) N

BRAKE SYSTEM (OTHER)  BRAKE FLUID(w/o Brake pedal Load Sensing Switch)  BLEEDING  


CAUTION / NOTICE / HINT

HINT:

If any work is done on the brake system or if air in the brake lines is suspected, bleed the system of air.


NOTICE:

Do not let brake fluid remain on a painted surface.Wash it off immediately.


PROCEDURE

Hide 1. FILL BRAKE RESERVOIR WITH BRAKE FLUID

Fluid:

SAE J1703 or FMVSS No. 116 DOT3


C397293

Hide 2.BLEED MASTER CYLINDER

HINT:

If the master cylinder has been disassembled or if the reservoir becomes empty, bleed the air from the master cylinder.


a.
C397294

Disconnect the brake lines from the master cylinder.


b.

Slowly depress the brake pedal and hold it.


c.
C397295

Block off the outer holes with your fingers, and release the brake pedal.


d.

Repeat (b) and (c) 3 or 4 times.


Hide 3.BLEED BRAKE LINE

C397296

a.

Connect the vinyl tube to the brake cylinder.


b.

Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down.


c.

At the point when fluid stops coming out, tighten the bleeder plug, then release the brake pedal.


d.

Repeat (b) and (c) until all the air in the fluid has been bled out.


e.

Repeat the above procedure to bleed the air out of the brake line for each wheel.


Hide 4.BLEED LSP & BV

Hide 5. CHECK FLUID LEVEL IN RESERVOIR

Check the fluid level and add fluid if necessary.

Brake Fluid:

SAE J1703 or FMVSS No. 116 DOT3

SAE J1704 or FMVSS No. 116 DOT4