Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/o Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356445 BRAKE MASTER CYLINDER(w/o Brake pedal Load Sensing Switch) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/o Brake pedal Load Sensing Switch)  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:

Do not remove the inlet union from the cylinder.


PROCEDURE

Hide 1. PLACE CYLINDER IN VISE

C397309

Hide 2.REMOVE NO. 1 OUTLET PLUG

Remove the No. 1 outlet plug, check valve, spring and gasket.

Hide 3.REMOVE NO. 2 OUTLET PLUG

C397310

a.

(Front Drum Brake)

Remove the No. 2 outlet plug, check valve, spring and gasket.


b.

(Front Disc Brake)

Remove the No. 2 outlet plug and gasket.


Hide 4.REMOVE PISTON STOPPER BOLT

C397311

Using a screwdriver, push the pistons in all the way and remove the piston stopper bolt.

HINT:

Tape the screwdriver tip before use.


Hide 5.REMOVE 2 PISTONS

a.
C397312

Push in the piston with a screwdriver and remove the snap ring with snap ring pliers.


b.

Remove the No. 1 piston and spring by hand, pulling straight out, not at an angle.

NOTICE:

If pulled out at an angle, there is a possibility that the cylinder bore could be damaged.



c.
C397313

Place a rag and 2 wooden blocks on the work table and lightly tap the cylinder flange against the block edges until the piston drops out of the cylinder.

HINT:

Make sure the distance (A) from the rag to the top of the blocks is at least 100 mm (3.94 in.).