Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/o Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356445 BRAKE MASTER CYLINDER(w/o Brake pedal Load Sensing Switch) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/o Brake pedal Load Sensing Switch)  REASSEMBLY  


PROCEDURE

Hide 1.APPLY LITHIUM SOAP BASE GLYCOL GREASE TO RUBBER PARTS OF PISTONS

C397314

Hide 2.INSTALL SPRINGS AND PISTONS

NOTICE:

Be careful not to damage the rubber lips on the pistons.


C397312

a.

Insert the 2 pistons and springs straight in, not at an angle.

NOTICE:

If inserted at an angle, there is a possibility of damaging the cylinder bore.



b.

Push in the piston with a screwdriver and install the snap ring with snap ring pliers.

HINT:

Tape the screwdriver tip before use.



Hide 3.INSTALL PISTON STOPPER BOLT

C397315

Using a screwdriver, push the pistons in all the way and install the piston stopper bolt over a new gasket. Torque the bolt.

Torque:

10 N*m (100 kgf*cm, 7 ft.*lbf)


Hide 4.INSTALL NO. 2 OUTLET PLUG

C397316

a.

(Front Drum Brake)

i.

Assemble the check valve and spring to the outlet plug.


ii.

Install a new gasket and the outlet plug assembly.

Torque:

67 N*m (685 kgf*cm, 50 ft.*lbf)




b.

(Front Disc Brake)

i.

Install the outlet plug and a new gasket.

Torque:

67 N*m (685 kgf*cm, 50 ft.*lbf)




Hide 5.INSTALL NO. 1 OUTLET PLUG

a.

Assemble the check valve and spring to the outlet plug.


b.

Install the outlet plug assembly and a new gasket.

Torque:

67 N*m (685 kgf*cm, 50 ft.*lbf)