Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (w/o Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356446 BRAKE BOOSTER(w/o Brake pedal Load Sensing Switch) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(w/o Brake pedal Load Sensing Switch)  INSTALLATION  


PROCEDURE

Hide 44610 1.INSTALL BRAKE BOOSTER

C397323

a.

Install the brake booster, and torque the 4 nuts.

Torque:

13 N*m (133 kgf*cm, 10 ft.*lbf)



Hide 2.CONNECT CLEVIS TO BRAKE PEDAL

a.

Install the pin to the clevis through the brake pedal.


b.

Secure the clevis pin with the clip.


Hide 3.ADJUST LENGTH OF BOOSTER PUSH ROD

C397324

a.

Set the SST on the master cylinder, and lower the pin until its tip slightly touches the piston.


b.
C397325

Turn the SST upside down, and position it on the booster.


c.

Measure for clearance between the booster push rod and pin head (SST).

Clearance:

0.2 mm (0.008 in.)



d.

Adjust the booster push rod length until the push rod lightly touches the pin head.

HINT:

When adjusting the push rod, depress the brake pedal so that the push rod sticks out.



Hide 4.CONNECT VACUUM HOSE TO BRAKE BOOSTER

Hide 5.INSTALL INSTRUMENT PANEL NO. 1 REINFORCEMENT AND INSTRUMENT PANEL NO. 2 REINFORCEMENT

Hide 55301 7.INSTALL INSTRUMENT PANEL