Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1HZ)
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356447 VACUUM PUMP(for 1HZ) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1HZ)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE VACUUM HOSE UNION

C397347

Remove the union bolt, union and 2 gaskets.

NOTICE:

Do not tighten the vise too tightly.


Hide 2.REMOVE CHECK VALVE

C397348

Remove the check valve and gasket.

Hide 3.REMOVE END COVER

a.
C397349

Remove the 3 bolts.


b.
C397350

Place the vacuum pump on vise, as shown in the illustration.

NOTICE:

Do not tighten the vice.



c.

Using a pin punch and hammer, drive out the 2 straight pins.


d.

Remove the end cover and 2 O-rings.


Hide 4.REMOVE ROTOR AND 4 BLADES

C397351

Hide 5.REMOVE GEAR

C397352

a.

Using soft jaws on the vise, clamp the gear in the vise.


b.

Remove the gear lock nut.


c.

Remove the gear and woodruff key.


Hide 6.REMOVE SNAP RING

C397353

Using snap ring pliers, remove the snap ring.

Hide 7.REMOVE ROTOR SHAFT

C397354

Using a plastic hammer, tap out the rotor shaft.

Hide 8.REMOVE BEARING

C397355

Using a press and 17 mm socket, press out the bearing.