Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 1HZ)
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356447 VACUUM PUMP(for 1HZ) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1HZ)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL BEARING TO ROTOR SHAFT

Using a press, install the bearing to the rotor shaft.

Hide 2.INSTALL ROTOR SHAFT

C397357

Using SST and a press, install the rotor shaft to the casing.

SST
09608-30012  

Hide 3.INSTALL SNAP RING

C397353

Using snap ring pliers, install the snap ring.

Hide 4.INSTALL ROTOR INTO CASING

C397358

Apply engine oil to the rotor and install it to the rotor shaft.

Hide 5.INSTALL 4 BLADES

a.

Apply engine oil to the blades.


b.

Install the 4 blades with the round end facing outward.


c.

Be sure that the blades and rotor surfaces are even.


Hide 6.INSTALL END COVER

a.
C397358

Place the vacuum pump on the vise, as shown in the illustration.

NOTICE:

Do not tighten the vise.



b.

Install a new O-ring.


c.

nstall the end cover and temporarily install the 3 bolts.


d.

Using a pin punch and hammer, drive in the 2 straight pins.


e.

Using soft jaws on the vise, place the vacuum pump in the vise.

NOTICE:

Do not tighten the vise too tightly.



f.

Tighten the 3 bolts.

Torque:

7.8 N*m (80 kgf*cm, 69 in.*lbf)



Hide 7.INSTALL CHECK VALVE

C397348

Install the check, valve with a new gasket.

Torque:

74 N*m (755 kgf*cm, 55 ft.*lbf)


Hide 8.INSTALL VACUUM HOSE UNION

C397347

Install the vacuum hose union with 2 new gaskets and install and torque the union bolt.

Torque:

14 N*m (143 kgf*cm, 10 ft.*lbf)


HINT:

Align and insert the union pin into the matching hole of the casing.


Hide 9.INSTALL GEAR

C397360

a.

Temporarily install the woodruff key, gear and lock nut to the pump.


b.

Using soft jaws on the vise, clamp the gear in the vise.


c.

Tighten the gear lock nut.

Torque:

110 N*m (1,122 kgf*cm, 81 ft.*lbf)