Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 14B) › 2017.01–2019.08
RM2850E _54 Brake _073226 BRAKE SYSTEM (OTHER) _0356441 VACUUM PUMP(for 14B) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 14B)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE VACUUM HOSE UNION

C397328

Remove the union bolt, union and 2 gaskets.

NOTICE:

Do not tighten the vise too tightly.


Hide 2.REMOVE CHECK VALVE

C397329

Remove the check valve and gasket.

Hide 3.REMOVE END COVER

a.
C397330

Remove the 3 bolts.


b.
C397331

Place the vacuum pump on vise, as shown in the illustration.

NOTICE:

Do not tighten the vice.



c.

Using a pin punch and hammer, drive out the 2 straight pins.


d.

Remove the end cover and 2 O-rings.


Hide 4.REMOVE ROTOR AND 4 BLADES

C397332

Hide 5.REMOVE GEAR

C397333

a.

Using soft jaws on the vise, clamp the gear in the vise.


b.

Remove the gear lock nut.


c.

Remove the gear and woodruff key.


Hide 6.REMOVE SNAP RING

C397334

Using snap ring pliers, remove the snap ring.

Hide 7.REMOVE ROTOR SHAFT

C397335

Using a plastic hammer, tap out the rotor shaft.

Hide 8.REMOVE BEARING

C397336

Using a press and 17 mm socket, press out the bearing.