1.REMOVE FOLLOWING PARTS
4 sliding bushings
8 dust boots
2.REMOVE CYLINDER BOOT SET RINGS AND CYLINDER BOOTS
Using a screwdriver, remove the 2 cylinder boot set rings and 2 cylinder boots from the cylinders.
3.REMOVE PISTONS FROM CYLINDERS
Place a wooden plate between the pistons and caliper, as shown.
Use compressed air to remove the 2 pistons from the cylinders.
Do not place your fingers in front of the pistons when using compressed air.
4.REMOVE PISTON SEALS FROM CYLINDERS
Using a screwdriver, remove the 2 piston seals from the cylinders.