Home › Brake › PARKING BRAKE › PARKING BRAKE ASSEMBLY(for Parking Brake Drum with Inner Diameter of 160 mm)
RM2850E _54 Brake _073229 PARKING BRAKE _0356452 PARKING BRAKE ASSEMBLY(for Parking Brake Drum with Inner Diameter of 160 mm) G

PARKING BRAKE  PARKING BRAKE ASSEMBLY(for Parking Brake Drum with Inner Diameter of 160 mm)  INSPECTION  


PROCEDURE

Hide 1.INSPECT PARKING BRAKE SHOE LINING THICKNESS

a.
C151895

Using a ruler, measure the thickness of the shoe lining.

Standard thickness::

4.0 mm (0.157 in.)


Minimum thickness::

1.5 mm (0.0591 in.)


If the lining thickness is equal to or less than the minimum value, or if there is any severe or uneven wear, replace the brake shoe.

NOTICE:

If the brake shoes need replacing, they must be replaced as a set.



Hide 2.INSPECT PARKING BRAKE DRUM SUB-ASSEMBLY

a.
C151894

Using a brake drum gauge or the equivalent, measure the inside diameter of the parking brake drum.

Standard inside diameter:

160 mm (6.30 in.)


Maximum inside diameter:

161 mm (6.34 in.)


If the inside diameter is greater than the maximum, replace the parking brake drum.


Hide 3.INSPECT PARKING BRAKE DRUM AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT

a.
C151896

Apply chalk to the inside surface of the drum, then position the brake shoe lining so that they fit together properly.

If the contact between the drum and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.

NOTICE:

Wipe off the chalk after the inspection.