Home › Brake › EXHAUST BRAKE › EXHAUST BRAKE RETARDER SOLENOID
RM2850E _54 Brake _073230 EXHAUST BRAKE _0356459 EXHAUST BRAKE RETARDER SOLENOID G

EXHAUST BRAKE  EXHAUST BRAKE RETARDER SOLENOID  INSPECTION  


PROCEDURE

Hide 1.REMOVE EXHAUST RETARDER SOLENOID

Hide 2. AIR TRAVEL CHECK

a.
C159850

Measure the resistance and check the results in accordance with the value(s) in the table below.

Standard resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 14.3 to 17.3Ω


HINT:

If the result is not as specified, replace the exhaust brake retarder solenoid.



b.
C397422

When blowing into the exhaust retarder side union, make sure that the air travels to the air cleaner.


c.
C397423

Apply battery voltage to the connector.


d.

When blowing into the exhaust retarder side union, make sure that the air travels to the vacuum tank side union.


Hide 3.INSTALL EXHAUST RETARDER SOLENOID