CAN COMMUNICATION SYSTEM TROUBLESHOOTING
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (See pagePower Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTINGClick Here).
PRECAUTIONS FOR STEERING SYSTEM HANDLING
Be careful when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.
PRECAUTIONS FOR SRS AIRBAG SYSTEM HANDLING
This vehicle is equipped with a Supplemental Restraint System (SRS) which includes parts such as airbags for the driver and front passenger. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may cause a serious accident. Before servicing (including removal/installation, inspection and replacement of parts), be sure to read Precaution for SRS(See pageVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTIONClick Here).
BUS LINE REPAIR
After repairing a bus line with solder, wrap the repaired part with electrical tape.
The CANL bus line and CANH bus line must be installed together at all times
When installing, make sure that these lines are twisted, because CAN bus lines are likely to be influenced by electrical noise if the bus lines are not twisted.
Leave approximately 80 mm (3.15 in.) loose in the twisted wires around the connector.
When repairing the CAN bus lines, do not change the length of the lines. (Make sure that the length of the CANH bus line and CANL bus line are the same.)
Do not use bypass wiring between connectors.
| *a | Bypass Wire |
The ability of the twisted bus lines to resist interference will be lost if bypass wiring is used.
Do not use a twisted pair of wires for bypass wiring.
CONNECTOR HANDLING
When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.
| *a | Tester Probe |
Use service wires to check the connector if it is impossible to check continuity from the rear of the connector.
| *a | Service Wire |
PRECAUTIONS FOR INSPECTING OR REPLACING CAN JUNCTION CONNECTOR
If the CAN junction connector is removed from the vehicle for inspection or replacement, make sure to install the CAN junction connector and all wire harnesses to their original locations with tape and clamps.
PRECAUTIONS WHEN REPLACING A GATEWAY FUNCTION EQUIPPED ECU (CENTRAL GATEWAY ECU [NETWORK GATEWAY ECU])
When using a gateway function equipped ECU (central gateway ECU [network gateway ECU]) that was previously installed on another vehicle, perform initialization of the sub bus monitoring ECU in order to clear stored bus information (See pagePower Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>UTILITYClick Here).
If the stored bus information does not match the current sub bus configuration, DTCs may be stored and fail-safe functions may operate.
It is not necessary to perform initialization of a gateway monitoring ECU (sub bus monitoring ECU) when using a sub bus monitoring ECU which was installed to another vehicle with the same sub bus configuration.
PRECAUTIONS FOR WHEN GATEWAY FUNCTION EQUIPPED ECU (CENTRAL GATEWAY ECU [NETWORK GATEWAY ECU]) DETECTS COMMUNICATION DTCS FOR ECUS NOT CONNECTED TO THE ECU
Refer to Precautions when replacing a gateway function equipped ECU (central gateway ECU [network gateway ECU]) with a used one from another vehicle and initialize the connection information of the ECU.
Clear the DTCs and check that no DTCs are output.