Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356689 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  U0073  Control Module Communication Bus OFF  U0100  Lost Communication with ECM / PCM  U0124  Lost Communication With Lateral Acceleration Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the ECM, yaw rate and acceleration sensor (airbag ECU assembly) and steering angle sensor (spiral with sensor cable sub-assembly) via CAN communication.

DTC No. DTC Detection Condition Trouble Area
U0073 Either of the following is detected:
1.

A bus OFF state occurs once or more within 0.1 seconds, 10 times in succession. (Sent signals cannot be received.)

2.

When the +BS terminal voltage is between 10 and 17.4 V, a delay in receiving data from the yaw rate sensor and steering angle sensor continues for 1 second or more.

3.

When the +BS terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession within 60 seconds.

-

The condition that a delay in receiving data from the yaw rate sensor and steering angle sensor occurs more than once within 5 seconds.



CAN communication system
U0100 When the +BS terminal voltage is between 10 and 17.4 V, and the vehicle speed is 15 km/h (9 mph) or more, data cannot be received from the ECM for 2 seconds or more.
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

ECM


U0124 Either of the following is detected:
1.

When the +BS terminal voltage is between 10 and 17.4 V, and the vehicle speed is 7 km/h or more, data from the acceleration sensor cannot be received for 1 second or more.

2.

When the +BS terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession within 60 seconds.

-

The condition that data from the acceleration sensor cannot be received occurs once or more within 5 seconds.



·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Acceleration sensor (Airbag ECU assembly)


U0126 Either of the following is detected:
1.

When the +BS terminal voltage is between 10 and 17.4 V, data from the steering angle sensor cannot be received for 1 second or more.

2.

When the +BS terminal voltage is between 10 and 17.4 V, the following occurs 10 times in succession.

-

The condition that data from the steering angle sensor cannot be received occurs once or more within 5 seconds.



·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Steering angle sensor (Spiral with sensor cable sub-assembly)



PROCEDURE

1.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Check the DTCs (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

HINT:

If the CAN communication system DTC and the relevant sensor DTCs are output simultaneously, troubleshoot the relevant sensor DTCs (for VSC system) after the CAN communication system returns to normal.



Result:
Result Proceed to
DTC (relating to CAN communication system) is output A
DTC is not output B



A

B