DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| ABS Motor Relay | ABS motor relay / ON or OFF | ON: Motor relay ON
OFF: Motor relay OFF |
- |
| Solenoid Relay | Solenoid relay / ON or OFF | ON: Solenoid relay ON
OFF: Solenoid relay OFF |
- |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed
OFF: Brake pedal released |
- |
| Parking Brake SW | Parking brake switch / ON or OFF | ON: Parking brake applied
OFF: Parking brake released |
- |
| FR Wheel ABS Control | Front RH ABS operation / Before or Operate | Before: No ABS operation
Operate: During ABS operation |
- |
| FL Wheel ABS Control | Front LH ABS operation / Before or Operate | Before: No ABS operation
Operate: During ABS operation |
- |
| RR Wheel ABS Control | Rear RH ABS operation / Before or Operate | Before: No ABS operation
Operate: During ABS operation |
- |
| RL Wheel ABS Control | Rear LH ABS operation / Before or Operate | Before: No ABS operation
Operate: During ABS operation |
- |
| FR Wheel Speed | Front RH wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326.4 km/h (202 mph) | Actual wheel speed | Similar speed as indicated on speedometer |
| FL Wheel Speed | Front LH wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Actual wheel speed | Similar speed as indicated on speedometer |
| RR Wheel Speed | Rear RH wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Actual wheel speed | Similar speed as indicated on speedometer |
| RL Wheel Speed | Rear LH wheel speed sensor reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) | Actual wheel speed | Similar speed as indicated on speedometer |
| ECU IG Power Voltage | ECU IG power supply voltage / too Low, Normal or too High | too Low: Below 9.5 V
Normal: 9.5 to 18.5 V too High: 18.5 V or higher |
- |
| Solenoid (SFRR) | ABS solenoid (SFRR) / ON or OFF | ON: Operates | - |
| Solenoid (SFRH) | ABS solenoid (SFRH) / ON or OFF | ON: Operates | - |
| Solenoid (SFLR) | ABS solenoid (SFLR) / ON or OFF | ON: Operates | - |
| Solenoid (SFLH) | ABS solenoid (SFLH) / ON or OFF | ON: Operates | - |
| Solenoid (SRRR) | ABS solenoid (SRRR) / ON or OFF | ON: Operates | - |
| Solenoid (SRRH) | ABS solenoid (SRRH) / ON or OFF | ON: Operates | - |
| Solenoid (SRLR) | ABS solenoid (SRLR) / ON or OFF | ON: Operates | - |
| Solenoid (SRLH) | ABS solenoid (SRLH) / ON or OFF | ON: Operates | - |
| Solenoid (SRCF) | Master cut solenoid (SRCF) / ON or OFF | ON: Operates | - |
| Solenoid (SRCR) | Master cut solenoid (SRCR) / ON or OFF | ON: Operates | - |
| Solenoid (SRMF) | Master cut solenoid (SMCF) / ON or OFF | ON: Operates | - |
| Solenoid (SRMR) | Master cut solenoid (SMCR) / ON or OFF | ON: Operates | - |
| Master Cylinder Sensor 1 | Master cylinder pressure sensor 1 reading / min.: 0.00 V, max.: 4.99 V | When brake pedal is released: 0.3 to 0.7 V | Reading increases when brake pedal is depressed |
| Vacuum Sensor 1 | Vacuum sensor 1 reading / min.: 0.00 V, max.: 4.99 V | Min.: 0 V
Max.: 4.99 V |
- |
| Vacuum Sensor 2 | Vacuum sensor 2 reading / min.: 0.00 V, max.: 4.99 V | Min.: 0 V
Max.: 4.99 V |
- |
| Test Mode | Test Mode operation / Normal or Test | Normal: Normal mode
Test: Test mode |
- |
| Number of DTC | Number of DTC recorded / min.: 0, max.: 255 | Min.: 0
Max.: 255 |
- |
ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| ABS Solenoid (SFRR) | ABS solenoid (SFRR) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFRH) | ABS solenoid (SFRH) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFLR) | ABS solenoid (SFLR) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFLH) | ABS solenoid (SFLH) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRRR) | ABS solenoid (SRRR) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRRH) | ABS solenoid (SRRH) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRLR) | ABS solenoid (SRLR) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRLH) | ABS solenoid (SRLH) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| TRC Solenoid (SRCF) | Master cut solenoid (SRCF) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| TRC Solenoid (SRCR) | Master cut solenoid (SRCR) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| TRC Solenoid (SRMF) | Master cut solenoid (SMCF) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| TRC Solenoid (SRMR) | Master cut solenoid (SMCR) | Solenoid ON / OFF | Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFRR & SFRH) | ABS Solenoid (SFRR and SFRH) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFLR & SFLH) | ABS Solenoid (SFLR and SFLH) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRRR & SRRH) | ABS Solenoid (SRRR and SRRH) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| ABS Solenoid (SRLR & SRLH) | ABS Solenoid (SRLR and SRLH) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| ABS Solenoid (SFRH & SFLH) | ABS Solenoid (SFRH and SFLH) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| TRC Solenoid (SRCF & SRCR) | Master cut solenoid (SRCF and SRCR) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| TRC Solenoid (SRMF & SRMR) | Master cut solenoid (SMCF & SMCR) | Solenoid ON / OFF | Vehicle condition: Vehicle stopped |
| ABS Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor can be heard
Vehicle condition: Vehicle stopped |