CHECK NO. 1 INTEGRATION RELAY
Disconnect the J68 and J69 No. 1 integration relay connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| J68-1 (IG) - J69-4 (E) | G - W-B | Ignition power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| J69-6 (+B) - J69-4 (E) | L - W-B | Battery power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| J69-4 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the J68 and J69 No. 1 integration relay connectors.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| J69-1 (ACT-) - Body ground | L - Body ground | Windshield washer motor operation signal | ·
Ignition switch ON ·
Washer switch off |
11 to 14 V |
·
Ignition switch ON ·
Washer switch off |
Below 1 V | |||
| J69-2 (RRA) - Body ground | LG - Body ground | Front wiper motor hi speed operation signal | ·
Ignition switch ON ·
Wiper switch in OFF position |
Below 1 V |
·
Ignition switch ON ·
Wiper switch in HI position |
11 to 14 V | |||
| J69-5 (RLA) - Body ground | L - Body ground | Front wiper motor low speed operation signal | ·
Ignition switch ON ·
Wiper switch in OFF position |
Below 1 V |
·
Ignition switch ON ·
Wiper switch in LO position |
11 to 14 V | |||
| J68-6 (PA2) - Body ground | R - Body ground | Windshield wiper switch position signal | ·
Ignition switch ON ·
Wiper switch not in HI position |
4.3 V or higher |
·
Ignition switch ON ·
Wiper switch in HI position |
Below 1 V | |||
| J68-7 (PA1) - Body ground | LG - Body ground | Windshield wiper switch position signal | ·
Ignition switch ON ·
Wiper switch not in LO position |
4.3 V or higher |
·
Ignition switch ON ·
Wiper switch in LO position |
Below 1 V | |||
| J68-8 (SPD) - Body ground | B - Body ground | Windshield wiper switch position signal | ·
Ignition switch ON ·
Wiper switch not in INT position |
4.3 V or higher |
·
Ignition switch ON ·
Wiper switch in INT position |
Below 1 V | |||
| J68-11 (+S) - Body ground | L - Body ground | Front wiper motor operation signal | Front wiper motor operates | Below 1 V |
| Front wiper motor stops | 5.5 V or higher | |||
| J68-12 (WU) - Body ground | V - Body ground | Washer switch signal | ·
Ignition switch ON ·
Washer switch off |
4.3 V or higher |
·
Ignition switch ON ·
Washer switch on |
Below 1 V |