Home › Engine / Hybrid System › 1HZ (INTAKE) › TURBOCHARGER
RM2850E _51 Engine / Hybrid System _073298 1HZ INTAKE _0356955 TURBOCHARGER L

1HZ INTAKE  TURBOCHARGER  PRECAUTION  


PRECAUTIONS


a.

Do not stop the engine immedialtely after pulling a trailer or high speed or uphill driving. Idle the engine for 20-120 seconds, depending on the severity of the driving condition.


b.

Avoid sudden racing or acceleration immediately after starting a cold engine.


c.

If the turbocharger is defective and must be replaced, first check for the cause of the defect in reference to the following items and replace parts if necessary:

·

Engine oil level and quality

·

Conditions under which the turbocharger was used

·

Oil lines leading to the turbocharger



d.
A423216

Use caution when removing and reinstalling the turbocharger assembly. Do not drop it or bang it against anything or grasp it by easily-deformed parts, such as the actuator or rod, when moving it.


e.

Before removing the turbocharger, plug the intake and exhaust ports and oil inlet to prevent entry of dirt or other foreign material.


f.
A423217

If replacing the turbocharger, check for accumulation of sludge particles in the oil pipes and, if necessary, replace the oil pipes.


g.

Completely remove the gasket adhered to the lubrication oil pipe flange and turbocharger oil flange.


h.

If replacing bolts or nuts, do so only with the specified new ones to guard against breakage or deformation.


i.
A423218

If replacing the turbocharger, put 20 cc (1.2 cu in.) of oil into the turbocharger oil inlet and turn the impeller wheel by hand to spread oil to the bearing.


j.

If overhauling or replacing the engine, cut the fuel supply after reassembly and crank the engine for 30 seconds to distribute oil throughout the engine. Allow the engine to idle for 60 seconds.