Home › Engine / Hybrid System › 1HZ (INTAKE) › TURBOCHARGER
RM2850E _51 Engine / Hybrid System _073298 1HZ INTAKE _0356955 TURBOCHARGER G

1HZ INTAKE  TURBOCHARGER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE AIR SYSTEM

a.

Check for leakage or clogging between the air cleaner and turbocharger inlet and between the turbocharger outlet and cylinder head.

·

Clogged air cleaner .... Clean or replace the element

·

Hoses collapsed or deformed .... Check each connection and repair

·

Cracks in components .... Check and replace



Hide 2.INSPECT EXHAUST SYSTEM

a.

Check for leakage or clogging between the cylinder head and turbocharger inlet and between the turbocharger outlet and exhaust pipe.

·

Deformed components .... Repair or replace

·

Foreign material in passages .... Remove

·

Leakage from components .... Repair or replace

·

Cracks in components .... Check and replace



Hide 3.CHECK TURBOCHARGING PRESSURE

a.

Warm up engine.


b.
A423219

Connect a 3-way union to the intake pipe pressure hose and install SST (turbocharger pressure gauge) to it.


c.

Press in the clutch pedal, then press the accelerator pedal down as far as it will go. Measure the turbo-charging pressure at maximum speed (4,400 rpm).

Standard pressure:

0.50 - 0.65 kg/cm2 (7.1 - 9.2 psi, 49 - 64 kPa)


If the pressure is less than specification, check the intake air and exhaust systems for leakage. If there is no leakage, replace the turbocharger assembly.

If the pressure is above specification, check if the actuator hose is disconnected or cracked. If not, replace the turbocharger assembly.


Hide 4.INSPECT IMPELLER WHEEL ROTATION

A423220

a.

Disconnect the air cleaner hose.


b.

Grasp the edge of the impeller wheel and turn it.

Check that it turns smoothly.

If it does not turn or if it turns with drag, replace the turbocharger assembly.