Home › Engine / Hybrid System › N04C-VL (INTAKE) › TURBOCHARGER
RM2850E _51 Engine / Hybrid System _073301 N04C-VL INTAKE _0356966 TURBOCHARGER G

N04C-VL INTAKE  TURBOCHARGER  INSPECTION  


PROCEDURE

Hide 1.CHECK TURBINE SHAFT ROTATION

a.
A342155

Check the turbine shaft.

i.

Hold the nut on the turbine shaft with your fingers and check that there is no remarkable looseness in the radial and axial directions.

HINT:

If the fins of the impeller and the turbine wheel are in contact with the housing because of the looseness, replace the turbocharger sub-assembly.




b.

Check the turbo housing.

i.

Visually check the turbine housing for damage or breaks.

HINT:

If any damage or breaks are found in the housings, replace the turbocharger sub-assembly.



ii.

Visually check the fins of the impeller and turbine wheel for damage or breaks.



Hide 2.INSPECT AXIAL PLAY OF TURBINE SHAFT

a.
A342156

Using a dial indicator, insert the needle of the dial indicator into the intake side of the turbine shaft.


b.

Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft.

Maximum axial play:

0.09 mm (0.00354 in.)


If the axial play is greater than the maximum, replace the turbocharger sub-assembly.


Hide 3.INSPECT RADIAL PLAY OF TURBINE SHAFT

a.
A342157

Using a dial indicator, insert the needle of the dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.


b.

Move the turbine shaft in the radial direction and measure the radial play of the turbine shaft.

Maximum radial play:

0.17 mm (0.00669 in.)


If the radial play is greater than the maximum, replace the turbocharger sub-assembly.