17410
1.INSTALL FRONT EXHAUST PIPE ASSEMBLY
Install a new gasket.
Temporarily install the front exhaust pipe with a new bolt, 2 spacers and 2 new nuts.
Temporarily install a new clamp bolt.
Tighten the bolt and 2 nuts.
70 N*m (714 kgf*cm, 52 ft.*lbf)
Tighten the clamp bolt.
25 N*m (259 kgf*cm, 19 ft.*lbf)
19971G
2.INSTALL VACUUM PIPE
Install the vacuum pipe with the 2 bolts.
29 N*m (296 kgf*cm, 21 ft.*lbf)
Connect the 2 vacuum hoses.
3.INSTALL TURBO INSULATOR
Install the No. 1 and No. 2 turbo insulators with the 8 bolts.
29 N*m (291 kgf*cm, 21 ft.*lbf)
17402
4.INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY
Install a new gasket.
Install the No. 2 exhaust pipe sub-assembly with the 3 new bolts.
43 N*m (438 kgf*cm, 32 ft.*lbf)
17420
5.INSTALL CENTER EXHAUST PIPE ASSEMBLY
Install the center exhaust pipe assembly with the 2 bolts.
43 N*m (438 kgf*cm, 32 ft.*lbf)
Install the 2 nuts.
19 N*m (194 kgf*cm, 14 ft.*lbf)
17420K
6.INSTALL NO. 2 CENTER EXHAUST PIPE ASSEMBLY
Inspect the compression spring.
Using a vernier caliper, measure the free length of the compression spring.
40 mm (1.57 in.)
If the free length is less than the minimum, replace the compression spring.
Install a new gasket.
Install the gasket in the correct direction.
Do not damage the outer surface of the gasket.
Do not reuse the removed gasket.
Do not push in the gasket with the No. 2 center exhaust pipe assembly when connecting it.
Install the No. 2 center exhaust pipe assembly with 4 new nuts.
19 N*m (194 kgf*cm, 14 ft.*lbf)
Tighten the 2 compression springs and the 2 bolts.
43 N*m (438 kgf*cm, 32 ft.*lbf)
17430
7.INSTALL EXHAUST TAILPIPE ASSEMBLY
Install a new gasket.
Install the exhaust tailpipe assembly with the bolt.
23 N*m (230 kgf*cm, 17 ft.*lbf)
Tighten 2 new nuts and the 2 bolts.
43 N*m (438 kgf*cm, 32 ft.*lbf)
8.INSPECT FOR EXHAUST GAS LEAK