Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER
RM2850E _51 Engine / Hybrid System _073293 2TR-FE STARTING _0357009 STARTER A

2TR-FE STARTING  STARTER  REASSEMBLY  


PROCEDURE

Hide 28160 1.INSTALL STARTER ARMATURE ASSEMBLY

a.

Install the starter armature to the starter yoke.


Hide 28140 2.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.

Place the brush holder assembly on the starter yoke.


b.
A062429

Using a screwdriver, install the 4 brushes.

NOTICE:

Check that the positive (+) lead wires are not grounded.



c.

Place a new O-ring in position on the commutator end frame.


d.

Install a new dust protector to the commutator end frame.


e.
A161131

Install the commutator end frame with the 2 screws.

Torque:

1.5 N*m (15 kgf*cm, 13 in.*lbf)



Hide 28150 3.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.
A161054E07
0.542,1.594 0.667,1.74 false 2.052,1.521 2.052,1.698 false 1.354,0.927 1.354,1.083 false 0.76,0.552 0.76,0.708 false 0.354,0.698 0.354,0.844 false 1.979,1.719 2.177,1.885 0.198,0.167 10 false (b) 0.323,1.458 0.521,1.625 0.198,0.167 10 false (c) 0.281,0.51 0.479,0.677 0.198,0.167 10 false (d) 0.698,0.365 0.896,0.531 0.198,0.167 10 false (e) 1.302,1.094 1.458,1.26 0.156,0.167 10 false (f)

Apply grease to the steel ball and install it into the starter clutch.


b.

Apply grease to the starter clutch, and install it onto the starter drive housing.


c.

Apply grease to the magnet switch return spring and install it onto the starter clutch.


d.

Apply grease to the clutch roller and install it onto the retainer.


e.

Apply grease to the retainer and install it onto the starter idle pinion.


f.

Apply grease to the starter idle pinion and install it onto the starter drive housing.


g.
A161053

Install the starter switch with the 2 screws.

Torque:

5.9 N*m (60 kgf*cm, 52 in.*lbf)



Hide 28120 4.INSTALL STARTER YOKE ASSEMBLY

a.

Place a new O-ring in position on the starter yoke.


b.
P013095E08
0.604,1.667 1.333,1.833 false 2.833,1.51 2.042,1.51 false 1.677,1.417 2.052,1.583 0.375,0.167 10 false Claw 1.406,1.76 1.979,1.948 0.573,0.188 10 false Groove

Install the starter yoke onto the starter switch.

HINT:

Align the claw of the starter yoke with the groove of the starter switch.



c.
A074096

Tighten the 2 through bolts.

Torque:

5.9 N*m (60 kgf*cm, 52 in.*lbf)



d.

Connect the lead wire to terminal C with the nut.

Torque:

5.9 N*m (60 kgf*cm, 52 in.*lbf)