Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › MASS AIR FLOW METER
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0356941 MASS AIR FLOW METER G

2TR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.

Check the output voltage.

i.
G037688E05
1.479,0.01 2.094,0.188 0.615,0.177 10 false Voltmeter

Apply battery voltage across terminals 1 (+B) and 2 (E2G).

NOTICE:

While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.



ii.

Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG) and the negative (-) tester probe to terminal 2 (E2G).


iii.

Blow air into the mass air flow meter, then check that the voltage fluctuates.

If the voltage does not fluctuate, replace the mass air flow meter.



b.

Check the resistance.

i.
A430855

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance:
Tester Connection Specified Condition
4 (THA) - 5 (E2) 12.5 to16.9 kΩ at -20°C (-4°F)
4 (THA) - 5 (E2) 2.19 to 2.67 kΩ at 20°C (68°F)
4 (THA) - 5 (E2) 0.50 to 0.68 kΩ at 60°C (140°F)


If the result is not as specified, replace the mass air flow meter.